Using oxygen isotope ratios to quantitatively assess trapping mechanisms during CO2 injection into geological reservoirs

the Pembina case study

G. Johnson, B. Mayer, M. Nightingale, M. Shevalier, I. Hutcheon

Research output: Contribution to journalArticle

39 Citations (Scopus)

Abstract

Carbon Capture and Storage (CCS) is considered a viable option for reducing CO2 emissions into the atmosphere from point sources such as coal-fired power plants. Monitoring of CO2 storage sites is widely considered necessary for safety reasons and for verification of injected CO2 in the reservoir. The latter is crucially dependent on the ability to determine CO2 trapping mechanisms and to assess pore-space saturation of CO2. Thus far, attempts to determine CO2 pore-space saturations at CO2 injection sites have had limited success. Here, we present data from the Pembina Cardium CO2 Monitoring Project in Alberta, Canada, that demonstrate that changes in the oxygen isotope ratios (δ18O) of reservoir water can be indicative of the extent of pore-space saturation with CO2. The δ18O value of injected CO2 at the injection site was + 28.6‰ (V-SMOW) and δ18O values of reservoir water at eight observation wells varied between − 13.5 and − 17.1‰ (V-SMOW) before CO2 injection. After commencement of CO2 injection the δ18O values of reservoir water at three observation wells increased between 1.1 and 3.9‰ due to the presence of large quantities of injected CO2 and equilibrium isotope exchange between water and CO2. Our calculations revealed that reservoir water fully saturated with CO2 would only result in increases of δ18OH2O values of 0.4‰. Hence the observed larger increases in δ18O values of reservoir water indicate free phase CO2 with estimated pore-space saturations ranging from 12% (corresponding to a δ18O increase of 1.1‰) to 64% (δ18O increase 3.9‰) of the non-oil saturated pore-space. Contributions to oxygen in the system from mineral dissolution were calculated to be less than 0.01% of total oxygen and therefore did not alter the δ18O value of the reservoir water significantly. Hence we conclude that changes in the δ18O values of reservoir water caused by the presence of injected CO2 can be used as a tracer for CO2 plume migration in the subsurface provided that the injected CO2 is isotopically distinct. Furthermore, we submit that the extent of the changes in the δ18O values of the reservoir water provides a quantitative assessment of CO2 stored in dissolved form (solubility trapping), assuming no density driven convective overturn, and as free-phase CO2 (structural, stratigraphic and hydrodynamic trapping) thereby elucidating the trapping mechanisms within the reservoir.
Original languageEnglish
Pages (from-to)185-193
Number of pages9
JournalChemical Geology
Volume283
Issue number3-4
DOIs
Publication statusPublished - 1 Apr 2011

Fingerprint

Oxygen Isotopes
oxygen isotope ratio
Isotopes
trapping
pore space
Oxygen
saturation
well
oxygen
Carbon capture
overturn
water reservoir
Coal
Monitoring
coal-fired power plant
water exchange
monitoring
Minerals
point source
Power plants

Keywords

  • carbon storage
  • oxygen
  • isotopes
  • reservoir saturation
  • geological reservoirs
  • carbon capture and storage

Cite this

@article{ca06b45388b04e34aebc2c70c1e4c294,
title = "Using oxygen isotope ratios to quantitatively assess trapping mechanisms during CO2 injection into geological reservoirs: the Pembina case study",
abstract = "Carbon Capture and Storage (CCS) is considered a viable option for reducing CO2 emissions into the atmosphere from point sources such as coal-fired power plants. Monitoring of CO2 storage sites is widely considered necessary for safety reasons and for verification of injected CO2 in the reservoir. The latter is crucially dependent on the ability to determine CO2 trapping mechanisms and to assess pore-space saturation of CO2. Thus far, attempts to determine CO2 pore-space saturations at CO2 injection sites have had limited success. Here, we present data from the Pembina Cardium CO2 Monitoring Project in Alberta, Canada, that demonstrate that changes in the oxygen isotope ratios (δ18O) of reservoir water can be indicative of the extent of pore-space saturation with CO2. The δ18O value of injected CO2 at the injection site was + 28.6‰ (V-SMOW) and δ18O values of reservoir water at eight observation wells varied between − 13.5 and − 17.1‰ (V-SMOW) before CO2 injection. After commencement of CO2 injection the δ18O values of reservoir water at three observation wells increased between 1.1 and 3.9‰ due to the presence of large quantities of injected CO2 and equilibrium isotope exchange between water and CO2. Our calculations revealed that reservoir water fully saturated with CO2 would only result in increases of δ18OH2O values of 0.4‰. Hence the observed larger increases in δ18O values of reservoir water indicate free phase CO2 with estimated pore-space saturations ranging from 12{\%} (corresponding to a δ18O increase of 1.1‰) to 64{\%} (δ18O increase 3.9‰) of the non-oil saturated pore-space. Contributions to oxygen in the system from mineral dissolution were calculated to be less than 0.01{\%} of total oxygen and therefore did not alter the δ18O value of the reservoir water significantly. Hence we conclude that changes in the δ18O values of reservoir water caused by the presence of injected CO2 can be used as a tracer for CO2 plume migration in the subsurface provided that the injected CO2 is isotopically distinct. Furthermore, we submit that the extent of the changes in the δ18O values of the reservoir water provides a quantitative assessment of CO2 stored in dissolved form (solubility trapping), assuming no density driven convective overturn, and as free-phase CO2 (structural, stratigraphic and hydrodynamic trapping) thereby elucidating the trapping mechanisms within the reservoir.",
keywords = "carbon storage, oxygen, isotopes, reservoir saturation, geological reservoirs, carbon capture and storage",
author = "G. Johnson and B. Mayer and M. Nightingale and M. Shevalier and I. Hutcheon",
year = "2011",
month = "4",
day = "1",
doi = "10.1016/j.chemgeo.2011.01.016",
language = "English",
volume = "283",
pages = "185--193",
journal = "Chemical Geology",
issn = "0009-2541",
number = "3-4",

}

Using oxygen isotope ratios to quantitatively assess trapping mechanisms during CO2 injection into geological reservoirs : the Pembina case study. / Johnson, G.; Mayer, B.; Nightingale, M.; Shevalier, M.; Hutcheon, I.

In: Chemical Geology, Vol. 283, No. 3-4, 01.04.2011, p. 185-193.

Research output: Contribution to journalArticle

TY - JOUR

T1 - Using oxygen isotope ratios to quantitatively assess trapping mechanisms during CO2 injection into geological reservoirs

T2 - the Pembina case study

AU - Johnson, G.

AU - Mayer, B.

AU - Nightingale, M.

AU - Shevalier, M.

AU - Hutcheon, I.

PY - 2011/4/1

Y1 - 2011/4/1

N2 - Carbon Capture and Storage (CCS) is considered a viable option for reducing CO2 emissions into the atmosphere from point sources such as coal-fired power plants. Monitoring of CO2 storage sites is widely considered necessary for safety reasons and for verification of injected CO2 in the reservoir. The latter is crucially dependent on the ability to determine CO2 trapping mechanisms and to assess pore-space saturation of CO2. Thus far, attempts to determine CO2 pore-space saturations at CO2 injection sites have had limited success. Here, we present data from the Pembina Cardium CO2 Monitoring Project in Alberta, Canada, that demonstrate that changes in the oxygen isotope ratios (δ18O) of reservoir water can be indicative of the extent of pore-space saturation with CO2. The δ18O value of injected CO2 at the injection site was + 28.6‰ (V-SMOW) and δ18O values of reservoir water at eight observation wells varied between − 13.5 and − 17.1‰ (V-SMOW) before CO2 injection. After commencement of CO2 injection the δ18O values of reservoir water at three observation wells increased between 1.1 and 3.9‰ due to the presence of large quantities of injected CO2 and equilibrium isotope exchange between water and CO2. Our calculations revealed that reservoir water fully saturated with CO2 would only result in increases of δ18OH2O values of 0.4‰. Hence the observed larger increases in δ18O values of reservoir water indicate free phase CO2 with estimated pore-space saturations ranging from 12% (corresponding to a δ18O increase of 1.1‰) to 64% (δ18O increase 3.9‰) of the non-oil saturated pore-space. Contributions to oxygen in the system from mineral dissolution were calculated to be less than 0.01% of total oxygen and therefore did not alter the δ18O value of the reservoir water significantly. Hence we conclude that changes in the δ18O values of reservoir water caused by the presence of injected CO2 can be used as a tracer for CO2 plume migration in the subsurface provided that the injected CO2 is isotopically distinct. Furthermore, we submit that the extent of the changes in the δ18O values of the reservoir water provides a quantitative assessment of CO2 stored in dissolved form (solubility trapping), assuming no density driven convective overturn, and as free-phase CO2 (structural, stratigraphic and hydrodynamic trapping) thereby elucidating the trapping mechanisms within the reservoir.

AB - Carbon Capture and Storage (CCS) is considered a viable option for reducing CO2 emissions into the atmosphere from point sources such as coal-fired power plants. Monitoring of CO2 storage sites is widely considered necessary for safety reasons and for verification of injected CO2 in the reservoir. The latter is crucially dependent on the ability to determine CO2 trapping mechanisms and to assess pore-space saturation of CO2. Thus far, attempts to determine CO2 pore-space saturations at CO2 injection sites have had limited success. Here, we present data from the Pembina Cardium CO2 Monitoring Project in Alberta, Canada, that demonstrate that changes in the oxygen isotope ratios (δ18O) of reservoir water can be indicative of the extent of pore-space saturation with CO2. The δ18O value of injected CO2 at the injection site was + 28.6‰ (V-SMOW) and δ18O values of reservoir water at eight observation wells varied between − 13.5 and − 17.1‰ (V-SMOW) before CO2 injection. After commencement of CO2 injection the δ18O values of reservoir water at three observation wells increased between 1.1 and 3.9‰ due to the presence of large quantities of injected CO2 and equilibrium isotope exchange between water and CO2. Our calculations revealed that reservoir water fully saturated with CO2 would only result in increases of δ18OH2O values of 0.4‰. Hence the observed larger increases in δ18O values of reservoir water indicate free phase CO2 with estimated pore-space saturations ranging from 12% (corresponding to a δ18O increase of 1.1‰) to 64% (δ18O increase 3.9‰) of the non-oil saturated pore-space. Contributions to oxygen in the system from mineral dissolution were calculated to be less than 0.01% of total oxygen and therefore did not alter the δ18O value of the reservoir water significantly. Hence we conclude that changes in the δ18O values of reservoir water caused by the presence of injected CO2 can be used as a tracer for CO2 plume migration in the subsurface provided that the injected CO2 is isotopically distinct. Furthermore, we submit that the extent of the changes in the δ18O values of the reservoir water provides a quantitative assessment of CO2 stored in dissolved form (solubility trapping), assuming no density driven convective overturn, and as free-phase CO2 (structural, stratigraphic and hydrodynamic trapping) thereby elucidating the trapping mechanisms within the reservoir.

KW - carbon storage

KW - oxygen

KW - isotopes

KW - reservoir saturation

KW - geological reservoirs

KW - carbon capture and storage

U2 - 10.1016/j.chemgeo.2011.01.016

DO - 10.1016/j.chemgeo.2011.01.016

M3 - Article

VL - 283

SP - 185

EP - 193

JO - Chemical Geology

JF - Chemical Geology

SN - 0009-2541

IS - 3-4

ER -