Detection of retinal signals using position sensitive microelectrode arrays

K Mathieson, W Cunningham, J Marchal, J Melone, M Horn, D Gunning, R Tang, C Wilkinson, V O'Shea, KM Smith, A Litke, E Chichilnisky, M Rahman

Research output: Contribution to journalArticle

5 Citations (Scopus)

Abstract

To understand the neural code, that the retina uses to communicate the visual scene to the brain, large-area microelectrode arrays are needed to record retinal signals simultaneously from many recording sites. This will give a valuable insight into how large biological neural networks (such as the brain) process information, and may also be important in the development of a retinal prosthesis as a potential cure for some forms of blindness. We have used the transparent conductor indium tin oxide to fabricated electrode arrays with approximately 500 electrodes spaced at 60 μm. The fabrication procedures include photolithography, electron-beam lithography, chemical etching and reactive-ion etching. These arrays have been tested electrically using impedance measurements over the range of frequencies important when recording extracellular action potentials (0.1-100kHz). The data has been compared to a circuit model of the electrode/electrolyte interface. One type of array (512 electrodes) behaves as theory would dictate and exhibits an impedance of 200 kΩ at 1kHz. The other array (519 electrodes) has an impedance of 350 kΩ at this frequency, which is higher than predicted by the models. This can perhaps be attributed to the difference in fabrication techniques. The 512-electrode array has been coupled to low-noise amplification circuitry and has recorded signals from a variety of retinal tissues. Example in vitro recordings are shown here.
LanguageEnglish
Pages51-56
Number of pages6
JournalNuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
Volume513
Issue number1-2
DOIs
Publication statusPublished - 1 Nov 2003

Fingerprint

Microelectrodes
Electrodes
electrodes
recording
brain
Brain
etching
impedance
blindness
Fabrication
fabrication
Electron beam lithography
retina
Reactive ion etching
impedance measurement
Photolithography
photolithography
Tin oxides
indium oxides
Indium

Keywords

  • microelectrode arrays
  • neural signals
  • in vitro recordings
  • electrode arrays

Cite this

Mathieson, K ; Cunningham, W ; Marchal, J ; Melone, J ; Horn, M ; Gunning, D ; Tang, R ; Wilkinson, C ; O'Shea, V ; Smith, KM ; Litke, A ; Chichilnisky, E ; Rahman, M. / Detection of retinal signals using position sensitive microelectrode arrays. In: Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment. 2003 ; Vol. 513, No. 1-2. pp. 51-56.
@article{e9a090cab8084a7fb32fbd8ab37957f8,
title = "Detection of retinal signals using position sensitive microelectrode arrays",
abstract = "To understand the neural code, that the retina uses to communicate the visual scene to the brain, large-area microelectrode arrays are needed to record retinal signals simultaneously from many recording sites. This will give a valuable insight into how large biological neural networks (such as the brain) process information, and may also be important in the development of a retinal prosthesis as a potential cure for some forms of blindness. We have used the transparent conductor indium tin oxide to fabricated electrode arrays with approximately 500 electrodes spaced at 60 μm. The fabrication procedures include photolithography, electron-beam lithography, chemical etching and reactive-ion etching. These arrays have been tested electrically using impedance measurements over the range of frequencies important when recording extracellular action potentials (0.1-100kHz). The data has been compared to a circuit model of the electrode/electrolyte interface. One type of array (512 electrodes) behaves as theory would dictate and exhibits an impedance of 200 kΩ at 1kHz. The other array (519 electrodes) has an impedance of 350 kΩ at this frequency, which is higher than predicted by the models. This can perhaps be attributed to the difference in fabrication techniques. The 512-electrode array has been coupled to low-noise amplification circuitry and has recorded signals from a variety of retinal tissues. Example in vitro recordings are shown here.",
keywords = "microelectrode arrays , neural signals , in vitro recordings , electrode arrays",
author = "K Mathieson and W Cunningham and J Marchal and J Melone and M Horn and D Gunning and R Tang and C Wilkinson and V O'Shea and KM Smith and A Litke and E Chichilnisky and M Rahman",
note = "6th International Conference on Position Sensitive Detectors, UNIV LEICESTER, LEICESTER, ENGLAND, SEP 09-13, 2002",
year = "2003",
month = "11",
day = "1",
doi = "10.1016/S0168-9002(03)02135-1",
language = "English",
volume = "513",
pages = "51--56",
journal = "Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment",
issn = "0168-9002",
number = "1-2",

}

Mathieson, K, Cunningham, W, Marchal, J, Melone, J, Horn, M, Gunning, D, Tang, R, Wilkinson, C, O'Shea, V, Smith, KM, Litke, A, Chichilnisky, E & Rahman, M 2003, 'Detection of retinal signals using position sensitive microelectrode arrays' Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, vol. 513, no. 1-2, pp. 51-56. https://doi.org/10.1016/S0168-9002(03)02135-1

Detection of retinal signals using position sensitive microelectrode arrays. / Mathieson, K; Cunningham, W; Marchal, J; Melone, J; Horn, M; Gunning, D; Tang, R; Wilkinson, C; O'Shea, V; Smith, KM; Litke, A; Chichilnisky, E; Rahman, M.

In: Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, Vol. 513, No. 1-2, 01.11.2003, p. 51-56.

Research output: Contribution to journalArticle

TY - JOUR

T1 - Detection of retinal signals using position sensitive microelectrode arrays

AU - Mathieson, K

AU - Cunningham, W

AU - Marchal, J

AU - Melone, J

AU - Horn, M

AU - Gunning, D

AU - Tang, R

AU - Wilkinson, C

AU - O'Shea, V

AU - Smith, KM

AU - Litke, A

AU - Chichilnisky, E

AU - Rahman, M

N1 - 6th International Conference on Position Sensitive Detectors, UNIV LEICESTER, LEICESTER, ENGLAND, SEP 09-13, 2002

PY - 2003/11/1

Y1 - 2003/11/1

N2 - To understand the neural code, that the retina uses to communicate the visual scene to the brain, large-area microelectrode arrays are needed to record retinal signals simultaneously from many recording sites. This will give a valuable insight into how large biological neural networks (such as the brain) process information, and may also be important in the development of a retinal prosthesis as a potential cure for some forms of blindness. We have used the transparent conductor indium tin oxide to fabricated electrode arrays with approximately 500 electrodes spaced at 60 μm. The fabrication procedures include photolithography, electron-beam lithography, chemical etching and reactive-ion etching. These arrays have been tested electrically using impedance measurements over the range of frequencies important when recording extracellular action potentials (0.1-100kHz). The data has been compared to a circuit model of the electrode/electrolyte interface. One type of array (512 electrodes) behaves as theory would dictate and exhibits an impedance of 200 kΩ at 1kHz. The other array (519 electrodes) has an impedance of 350 kΩ at this frequency, which is higher than predicted by the models. This can perhaps be attributed to the difference in fabrication techniques. The 512-electrode array has been coupled to low-noise amplification circuitry and has recorded signals from a variety of retinal tissues. Example in vitro recordings are shown here.

AB - To understand the neural code, that the retina uses to communicate the visual scene to the brain, large-area microelectrode arrays are needed to record retinal signals simultaneously from many recording sites. This will give a valuable insight into how large biological neural networks (such as the brain) process information, and may also be important in the development of a retinal prosthesis as a potential cure for some forms of blindness. We have used the transparent conductor indium tin oxide to fabricated electrode arrays with approximately 500 electrodes spaced at 60 μm. The fabrication procedures include photolithography, electron-beam lithography, chemical etching and reactive-ion etching. These arrays have been tested electrically using impedance measurements over the range of frequencies important when recording extracellular action potentials (0.1-100kHz). The data has been compared to a circuit model of the electrode/electrolyte interface. One type of array (512 electrodes) behaves as theory would dictate and exhibits an impedance of 200 kΩ at 1kHz. The other array (519 electrodes) has an impedance of 350 kΩ at this frequency, which is higher than predicted by the models. This can perhaps be attributed to the difference in fabrication techniques. The 512-electrode array has been coupled to low-noise amplification circuitry and has recorded signals from a variety of retinal tissues. Example in vitro recordings are shown here.

KW - microelectrode arrays

KW - neural signals

KW - in vitro recordings

KW - electrode arrays

U2 - 10.1016/S0168-9002(03)02135-1

DO - 10.1016/S0168-9002(03)02135-1

M3 - Article

VL - 513

SP - 51

EP - 56

JO - Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment

T2 - Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment

JF - Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment

SN - 0168-9002

IS - 1-2

ER -