| Status | Finished |
|---|---|
| Effective start/end date | 1/02/14 → 31/01/19 |
Funding
- European Commission - FP7 - European Research Council: £1,722,288.00
Related content
Research Output
Influence of microphone housing on the directional response of piezoelectric MEMS microphones inspired by Ormia ochracea
Research output: Contribution to journal › Article
Active hearing mechanisms inspire adaptive amplification in an acoustic sensor system
Research output: Contribution to journal › Article
Mechanical specializations of insect ears
Research output: Chapter in Book/Report/Conference proceeding › Chapter
New ormia-inspired directional MEMS microphone operating in a low frequency band
Research output: Contribution to journal › Conference Contribution
Bio-inspired active amplification in a MEMS microphone using feedback computation
Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
Bio-inspired 3D-printed piezoelectric device for acoustic frequency selection
Research output: Contribution to journal › Article
Acoustic communication: body size versus frequency tuning as a balancing act
Research output: Contribution to conference › Poster
Evolution of directional hearing in moths via conversion of bat detection devices to asymmetric pressure gradient receivers
Research output: Contribution to journal › Article
Elastic constant determination of unidirectional composite via ultrasonic bulk wave through transmission measurements: a review
Research output: Contribution to journal › Article
Extreme call amplitude from near-field acoustic wave coupling in the stridulating water insect Micronecta scholtzi (Micronectinae)
Research output: Contribution to journal › Article
Mating vibrational signal transmission through and between plants of an agricultural pest, the Glassy-Winged Sharpshooter
Research output: Contribution to journal › Meeting abstract
Nanoscale coatings for ultralow dose BMP-2-driven regeneration of critical-sized bone defects
Research output: Contribution to journal › Article
Development of a biologically inspired MEMS microphone
Research output: Contribution to conference › Paper
Measured beam patterns of biomimetic receivers improve localisation performance of an ultrasonic sonar
Research output: Contribution to conference › Paper
Ultrasonic sonar system for target localization with one emitter and for receivers
Research output: Contribution to conference › Paper
Simple ears for clever microphones: biomechanical investigation of insect ears for novel acoustic sensors
Research output: Contribution to conference › Poster
Features in geometric receiver shapes modelling bat-like directivity patterns
Research output: Contribution to journal › Article
A MEMS microphone inspired by Ormia for spatial sound detection
Research output: Contribution to conference › Paper
Bio-inspired frequency agile acoustic system
Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
Airborne broad-beam emitter from a capacitive transducer and a cylindrical structure
Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
3D printed small-scale acoustic metamaterials based on Helmholtz resonators with tuned overtones
Research output: Contribution to conference › Paper
Hearing on the fly: the effects of wing position on noctuid moth hearing
Research output: Contribution to journal › Article
Enhancing the sound absorption of small-scale 3D printed acoustic metamaterials based on Helmholtz resonators
Research output: Contribution to journal › Article
Floral evolution: breeding systems, pollinators, and beyond
Research output: Contribution to conference › Poster
The anti-bat strategy of ultrasound absorption: the wings of nocturnal moths (Bombycoidea: Saturniidae) absorb more ultrasound than the wings of diurnal moths (Chalcosiinae: Zygaenoidea: Zygaenidae)
Research output: Contribution to journal › Article
Biomechanical alterations following acoustic trauma in Schistocerca gregaria
Research output: Contribution to conference › Poster
3D-printing polymer-based permanent magnets
Research output: Contribution to journal › Article
A non-destructive virtual dissection by micro-CT reveals diagnostic characters in the type specimen of Caloptilia stigmatella (Lepidoptera: Gracillariidae)
Research output: Contribution to journal › Article
DEMO: multimodal sensing system for hearing enhancement and research
Research output: Contribution to conference › Other
Bioinspired 3D-printed piezoelectric device for acoustic frequency separation
Research output: Contribution to conference › Other
Piezoelectric microphone via a digital light processing 3D printing process
Research output: Contribution to journal › Article
Distribution of sound pressure around a singing cricket: radiation pattern and asymmetry in the sound field
Research output: Contribution to journal › Article
Biologically inspired acoustic sensors: from insect ears to miniature microphones
Research output: Contribution to journal › Meeting abstract
Insect ear biomechanics: passive and active processes that can inspire acoustic sensors
Research output: Contribution to journal › Meeting abstract
Insect-inspired acoustic micro-sensors
Research output: Contribution to journal › Article
Towards the development of a frequency agile MEMS acoustic sensor system
Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
"Pipe organ" inspired air-coupled ultrasonic transducers with broader bandwidth
Research output: Contribution to journal › Article
Housing influence on multi-band directional MEMS microphones inspired by Ormia ochracea
Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
A low frequency dual-band operational microphone mimicking the hearing property of Ormia ochracea
Research output: Contribution to journal › Article
Simple ears inspire frequency agility in an engineered acoustic sensor system
Research output: Contribution to journal › Article
Evolution of directional hearing in moths: conversion of bat detection devices to asymmetric pressure gradient receivers
Research output: Contribution to conference › Poster
Activities
Insect Ears as Inspiration for Acoustic Systems
Activity: Talk or presentation types › Invited talk
Bioinspiration: From Simple Ears to Simple Microphones
Activity: Talk or presentation types › Oral presentation
3D-Printed cellular electret sensor for acoustic applications
Activity: Talk or presentation types › Oral presentation
Development of new acoustic systems inspired by Nature
Activity: Talk or presentation types › Invited talk
University of Southampton Physics Invited Talk
Activity: Talk or presentation types › Invited talk
Why do Engineers care what Insects can hear?
Activity: Talk or presentation types › Invited talk
Shira D. Gordon
Activity: Hosting a visitor types › Hosting an academic visitor
The Moth's Ear
Activity: Talk or presentation types › Invited talk
Sensor of the Week: The mighty moth
Activity: Other activity types › Types of Public engagement and outreach - Media article or participation
MicroTech 2016
Activity: Participating in or organising an event types › Participation in conference
Researchers in the Spotlight - Why Do We Care What an Insect Can Hear?
Activity: Talk or presentation types › Invited talk
Bioacoustics - Investigation of hearing systems in insects to inspire the development of new acoustic and ultrasonic sensors and systems
Activity: Talk or presentation types › Invited talk
Datasets
Equipment
ARCHIE-WeSt (UOSHPC)
Facility/equipment: Facility